Close Window
 

9931 Structured Tooth Tungsten Carbide Cutter (Taper)

A high-speed cutter with teeth made of tungsten carbide, the hardest material next to diamonds.

    • Use on fiberglass, wood, plastic, epoxy, rubber, laminates, particleboard and ceramic tile
    • Teeth made of tungsten carbide, the hardest material next to diamonds
    • Sharp teeth for greater material removal
    • Fast cutting
User Tips
  • For best results, insert the accessory bit all the way into the tool and then back it out slightly before tightening down. This provides plenty of shank for the collet or chuck to hold onto the bit.
  • Secure objects to a stable surface while working.
  • Use the sides of the cutter (rather than the tip) for effective cutting. The tip cuts poorly and can break under pressure.
  • Use higher speeds for hard woods, slower speeds for metals and very slow speeds for plastics (to avoid melting at the point of contact).
  • If chattering occurs, increase speed.
  • BIT DIAMETER INCH: 1/4"
  • BIT DIAMETER MM: 6.4 mm
* Model Number:9931

Speed Settings
View Speed Settings

9931 Structured Tooth Tungsten Carbide Cutter (Taper)

Looking for additional literature?

Request Literature

Contact the Dremel Experts for additional assistance

Australia
Phone: 1-300-30-70-44
8 am - 5 pm

New Zealand
Phone: 0-800-54-33-53
8 am - 5 pm

Online:

Submit a question