107 Engraving Cutter

Engraving cutter. Quality cutters for detail engraving, carving and routing in wood, fiberglass, plastic and soft metals. Two cutters included.

Share this:

107 Engraving Cutter

  • For detail engraving, carving and routing
  • For wood, fiberglass, plastic & soft materials
  • Not for use with hardened materials
  • Use higher speeds for hard woods, slower speeds for metals and very slow speeds for plastics
  • 1/8" shank

Accessories



  • 107 Engraving Cutter (2)
User Tips
  • Secure objects to a stable surface while working.
  • For best results, insert the accessory bit all the way into the tool and then back it out slightly before tightening down. This provides plenty of shank for the collet or chuck to hold onto the bit.
  • Use the sides of the cutter (rather than the tip) for effective cutting. The tip cuts poorly and can break under pressure.
  • Use higher speeds for hard woods, slower speeds for metals and very slow speeds for plastics (to avoid melting at the point of contact).
  • If chattering occurs, increase speed.

107 Engraving Cutter

  • BIT DIAMETER INCH: 3/32"
  • BIT DIAMETER MM: 2.4 mm
  • DESCRIPTION (AU): Engraving Cutter
  • OVERALL LENGTH: 1.5

107 Engraving Cutter

107 Engraving Cutter

Looking for additional literature?

Request Literature

Contact the Dremel Experts for additional assistance

Australia
Phone: 1-300-30-70-44
8 am - 5 pm

New Zealand
Phone: 0-800-54-33-53
8 am - 5 pm

Online:

Submit a question

107 Engraving Cutter

107 Engraving Cutter

Tool Kit Options

This tool is available as part of a kit.

More from Dremel

Join our Mailing List

See our Facebook page

Dremel Weekends