Bottle Stoppers

    Pick up a bottle stopper starter kit or re-use a piece of soft wood to create unique conversation pieces or holiday gifts that will be used for years to come.

    Step15

    Step 1

    use dremel to hold the piece of wood

    You need:

    Sketch your design onto your chosen wood piece as a guide. You can use one of our design ideas or create one of your own!

    Step25

    Step 2

    cut a wood piece to size

    You need:

    Using your Saw-Max equipped with a SM500 Wood & Plastic Wheel, cut your wood piece to size. We re-used an old chair leg as our material for this project. If your wood piece is thicker than 3/4" of an inch, you may need to flip or rotate your material to complete your cut.

    Step35

    Step 3

    engraving design on different angle
    engrave design
    engraving design on different angle
    engrave design

    You need:

    Secure your piece of wood in a vice & using your FortiFlex tool paired with a 117 High-Speed Cutter bit, remove the initial material from your carving. Once the larger portions of material is removed & you have a general shape you're happy with, switch to 9910 & 7103 accessories to add more detail. TIP: For tips on how to set up your new FortiFlex tool, CLICK HERE. When carving your piece, be sure not to remove an excessive amount of material so you can drill a 7/32" hole about 1" into your wooden piece on step 4.

    Step45

    Step 4

    shape bottom of wood

    You need:

    Finally, you'll need to drill through the bottom of your wood carving. We found detailed instructions for our bottle stopper starter kit here: Woodcraft.com Woodcraft's instructions adjusted for our project: Using a 7/32" bit, drill a 1" deep hole in a piece of wood any size you wish that is longer than the threaded stem on the wine stopper. A few drops of CA glue, or epoxy, in the threaded hole of the wood, prior to screwing it onto the stopper, will securely fix the wood to the stopper. Slide an O-ring (A) into each groove in the stopper body.

    Step55

    Step 5

    graphic on measurments

    You need:

    Models used