Candle Holder Center Piece

Candle Holder Center Piece

  • Difficulty
    Easy

Bring some ambiance to the table by etching leaves into candle holders for a new seasonal center piece. Now you can do it with less dust and debris while using the first ever Dremel Vacuum Powered Rotary Tool.

You need
  • Shop Vacuum
  • Tape
  • Pattern
L: Length, W: Width, H: Height, D: Diameter
Step 1 2

Step 1

Tape the paper inside the candle holder

You need: Dremel 105 Engraving Bit, Pattern, Tape, Shop Vacuum

To start your project, print or draw a seasonal pattern onto a piece of paper. Then, tape the paper inside the candle holder to act as a guide when etching.

Step 2 2

Step 2

Etch into the glass using the Dremel tool
Candle holder ready to use

Lastly, using the VRT1 and your wet/dry vacuum, etch into the glass using the VRT1. You will have much less dust and debris in your work area when using the VRT1 on small, dusty projects such as this!