Catchall Organizer

Catchall Organizer

  • Difficulty
    Hard

This week we're sharing a surprise project brought to you by this month's Featured Blogger - Jamie Roubinek of Roubinek Reality. Check out her blog here for other DIY projects, recipes & much much more!

You need
  • Clamps
  • Foam brush
  • 8 foot 1x4s
  • 8 foot 1x2
  • 1" Finishing nails
  • 3/4" Screws
  • 12x12 Sheet metal
  • Mason Jars
  • Stain of your choice
L: Length, W: Width, H: Height, D: Diameter
Step 1 13

Step 1

making cuts every 27 5/8" with your Dremel Saw-Max equipped with a SM500 wheel.
making cuts every 27 5/8" with your Dremel Saw-Max equipped with a SM500 wheel.

Measure and mark your cut lines on your 1x4s, making cuts every 27 5/8" with your Dremel Saw-Max equipped with a SM500 wheel. You will need 5 slats, total. You'll also use the same tool to cut 4 1x2s 18 1/2" long.

Step 2 13

Step 2

square on wooden panel
sand wooden panel

Line up your wood and check to make sure your cuts are correct. For those cuts that might be a little off, you can use the Dremel 3000 sanding attachment to sand them down to the right measurement. It's also perfect for smoothing out the rough edges of your 1x4 slats.

Step 3 13

Step 3

stain wood

Stain all of your wood, using your preferred stain color. For this project I used MinWax® Dark Walnut. After a few minutes, use a towel to wipe off stain that did not soak into the wood.

Step 4 13

Step 4

nail wood
glue wood

Line your slats up along the 1x2s, using wood glue and clamps to secure them. Once your wood glue has dried, hammer your 1" nails in.

Step 5 13

Step 5

hammer corner

Glue, clamp, and hammer in your 1x2s on to the top and bottom of the slats.

Step 6 13

Step 6

dril screws
drill square on panel

Once you have decided where you would like to place your sheet metal, you will need to drill pilot holes in to your metal.

Step 7 13

Step 7

frame the square

Screw your metal into the wood using 3/4" screws.

Step 8 13

Step 8

drill circle

To frame your sheet metal, lay out your wood and find your correct measurements. I was able to cut two pieces of 1x2 at 10 3/4" and two pieces at 11 1/2". Once your wood pieces are stained, glue them down and nail them in to your wood slats.

Step 9 13

Step 9

drill wood

Just like you made a pilot hole in your sheet metal, you will also need to use the same bit to create a larger hole in your hose clamp. A screw will not fit through the the holes of the hose clamp.

Step 10 13

Step 10

circle metal thing

Drill a pilot hole in your wood where you would like to attach your mason jars.

Step 11 13

Step 11

drill wood

Screw your collar into the wood using a 3/4" screw.

Step 12 13

Step 12

drill wood

Place your mason jar inside the collar and tighten the hose clamp as tight as possible.

Step 13 13

Step 13

drill wood
drill wood

Align your last three mason jars where you would like them and repeat steps 9, 10, 11, and 12