Etched Plate Charger

Set your table this Thanksgiving with personalized plate chargers

  • Difficulty
    Easy

Introduction

You need
  • Paper
  • Scissors
  • Marker
  • Tape
  • Paint
  • 2 x Plate Chargers
L: Length, W: Width, H: Height, D: Diameter
Step 1 3

Step 1

Begin by placing paper on the charger and tracing the inner circle with a marker to guide you when cutting it out

Begin by placing paper on the charger and tracing the inner circle with a marker to guide you when cutting it out. Tape it to the part of the charger you do not want to paint.

Step 2 3

Step 2

Remove the paper to give you a perfect ring of paint

Remove the paper to give you a perfect ring of paint on the outside of the charger.

Step 3 3

Step 3

Create a variety of plate chargers and use them at your Thanksgiving table this year

Lastly, draw a pattern onto the charger. Then, use the Dremel rotary tool and bit to etch the pattern into the charger. Use the side of the accessory rather than the tip for effective engraving. Create a variety of plate chargers and use them at your Thanksgiving table this year!