Heart Goes Boom Case

Dremel Rotary Tool can transform a vintage suitcase into an amazing BoomBox

  • Difficulty
    Medium

Introduction

You need
  • Screwdriver
  • Measuring Tape
  • Vintage suitcase constructed of plywood
  • FlushMounted Speakers & Accompanying Screws
  • Auxiliary Cable (for source hookup)
L: Length, W: Width, H: Height, D: Diameter
Step 1 4

Step 1

Measuring the diameter of the speaker

For best results, we recommend using surface mount subwoofers, tweeter, and mids for your project Begin by measuring the diameter of the speaker from the inside lip. Divide the measurement in half to determine the radius of your circle. The radius will be the distance from the pin on your circle cutting guide to the center of your bit. TIP: If the interior of your suitcase is lined with fabric, you will want to use a sharp-edge razor or scissors to cut away the lining from the area you cut into in step 2.

Step 2 4

Step 2

Marking at the center of the suitcase
Plunge cutting into the mark using Dremel Rotary tool

Create a mark at the center of where you’d like to place your main speaker. Mount the 561 Multipurpose Cutting Bit into your favorite Dremel Rotary Tool (we used the 300 Series tool). Set your tool to high speed and, holding the tool perpendicular to your case, make a plunge cut into the mark. This hole will serve as your pilot hole for the Circle Cutting Guide. Next, with your Circle Cutting Guide adjusted to your desired width per your measurements in step 1, place the guide pin in the pilot hole. Set your tool to high speed and plunge rotary bit into material cutting in a clockwise motion. TIP: To assemble the cutter, unscrew the pivot foot knob and turn the picot foot over so that the center point is down. Next, remove the nosecap of the 3000 tool then thread the Guide onto the threaded portion of the tool, turning clock

Step 3 4

Step 3

Place speakers into the respective holes
Screwing to secure the speakers

Place your speakers into their respective holes (you’ll notice it will be a snug fit). Use appropriate size screws to secure each speaker to your suitcase.

Step 4 4

Step 4

Following wiring instructions
Boarding a hole using Dremel 3000

Follow your speaker’s manufacture instructions for wiring. We board out a hole at the bottom of our case to feed our power cable through. To do this, we secured the 117 HighSpeed Cutting accessory into our 3000 tool, set the tool to high and board a hole roughly the diameter of the cable.