Build a tape dispenser to add convenience to your workbench.

Introduction

You need
  • Drill
  • Screws
  • Hacksaw Blade
  • Wood- Oak
  • Metal Rod- 1.25" diameter
  • Metal Bar Mounts- sized to fit rod
L: Length, W: Width, H: Height, D: Diameter
Step 1 9

Step 1

sand wooden pieace

Begin by cutting the wood with the Dremel Ultra-Saw to create the front and sides of the dispenser to the desired size. Then, using the Dremel Micro and cutting bit, drill pilot holes into the wood in all four corners of the front piece.

Step 2 9

Step 2

drill corner

Attach the metal bar mounts to the side pieces with the drill.

Step 3 9

Step 3

drill a line

Assemble the front and sides by drilling screws into the four corners of the front-facing piece of wood.

Step 4 9

Step 4

saw metal

Secure the hacksaw blade to the side of the front-facing piece of wood that will face outward, so it will cleanly slice the tape off the dispenser.

Step 5 9

Step 5

dremel with metal

Then, cut the diamond plate using the Ultra-Saw and metal cutting wheel, again to the desired size.

Step 6 9

Step 6

drill metal pieace

Using the Dremel Micro again, drill two pilot holes in the center of both of the shorter sides of the diamond plate, about an inch apart. Then, continuing to use the Micro, drill holes into the four corners, and next to the holes created for the mounting bars.

Step 7 9

Step 7

attach to wall

Next, attach the diamond plate to the bar mounts by drilling screws into the bars and plate, using the center holes as a guide.

Step 8 9

Step 8

insert tape

Then, secure the fixture to the wall with the drill.

Step 9 9

Step 9

all done

Finally, cut the white metal rod with the Ultra-Saw to desired size, fill the bar with tape and attach to the metal bar mounts inside of the fixture. Pull the edges of tape over the top of the wood so it is ready to use when you need it.