Tennis Ball Holders

Create your own tennis ball holder

  • Difficulty
    Easy

For simple kid-friendly organization, re-use extra tennis balls to create modular holders with tons of personality!

You need
  • Dremel 150 1/8" Drill Bit
  • Screwdriver
  • Screws
  • 932 Aluminum Oxide Grinding Stone
  • Standard tennis balls
L: Length, W: Width, H: Height, D: Diameter
Step 1 5

Step 1

make a cut across 1/2 of the tennis ball

This project can be accomplished in just a couple easy steps. You’ll want to make a cut across 1/2 of the tennis ball. To make this slit as clean and precise as possible, we recommend using a Dremel high-speed rotary tool like the NEW Dremel 4200. Get started by plunging pilot holes at the beginning and end of where your slit will fall. We made our slits about 4 inches long so we made two pilot holes 4" apart using our 4200 and the 1/8" Drill Bit. To insert the bit, pull back on the EZ Lock levers on the tool, insert the bit completely then back it out just slightly and push the levers forward to secure the bit. Plug in your tool, set it to high speed, and lightly plunge into the tennis ball at both pilot points. For the safest execution of this project and best results, we recommend securing your tennis ball in a vice before making any cuts on it.

Step 2 5

Step 1

Plung pilot holes at the beginning and end of where your slit will fall

This project can be accomplished in just a couple easy steps. You’ll want to make a cut across 1/2 of the tennis ball. To make this slit as clean and precise as possible, we recommend using a Dremel high-speed rotary tool like the NEW Dremel 4200. Get started by plunging pilot holes at the beginning and end of where your slit will fall. We made our slits about 4 inches long so we made two pilot holes 4" apart using our 4200 and the 1/8" Drill Bit. To insert the bit, pull back on the EZ Lock levers on the tool, insert the bit completely then back it out just slightly and push the levers forward to secure the bit. Plug in your tool, set it to high speed, and lightly plunge into the tennis ball at both pilot points. For the safest execution of this project and best results, we recommend securing your tennis ball in a vice before making any cuts on it.

Step 3 5

Step 2

Cut in tennis ball

Once you have made your pilot holes, you'll need to change accessories to complete the slit connecting the two pilot points together. Unplug your tool, pull back on the EZ Change Levers to remove the drill bit and insert a 543 Cutting Wheel. We recommend this wheel as it completes clean cuts in flexible materials like plastics and laminates. Set your tool to a speed setting of 5 and begin cutting from one pilot point to another, applying light pressure.

Step 4 5

Step 3

Cut circle in tennis ball

If you are sitting the holder on a flat surface, you’ll need to even the bottom by shaving off about 1/4" of the ball so it will sit level on your surface. With the ball positioned in your vice, use the same technique as step two to complete your cut with the 543 accessory. Remember to run your tool at a speed setting of 5 here for maximum control.

Step 5 5

Step 4

Sand inside tennis ball

If you are mounting the holder to your wall, secure a thin screw into the back of the holder.