by Dremel ®
Tools & Accessories
1Dremel 335-01 Plunge Router Attachment
1Dremel A577 Detailer’s Grip Attachment
1Wooden base- we found ours at a florist
Let's Get Started
To reduce the risk of injury user must read instruction manuals for all tools used in this project. Wear eye and respiratory protection. Use clamps to support work piece whenever practical.
Begin your project by measuring the width and depth of your phone. Then, take these dimensions and transfer them over to the wooden base, drawing a rectangle around the wood to guide you when cutting.
Next, use your Dremel rotary tool, plunge router attachment and accessory to remove the wood in layers, following the rectangle you traced onto the wood. If you use the plunge router 3 or 4 times smoothly, you should not need to sand the wood down. However, if it does need to be smoothed, simply take a small piece of sand paper and rub the rough area down. Safety Tip: Wear safety glasses.
Then, remove the Dremel rotary tool from the router attachment and add the detailer's grip attachment, if using. Using a drill bit that is the same diameter as the thickness of your charging connector, drill two holes next to one another to form a slot.
Next, flip the wooden base over, and thread the charging connector from the bottom, up through the base so it is sticking out of the top. The wood will be nearly the same size of the charger, keeping the charger in place. Secure the feet of the base per its instructions, adding support and keeping the charging station from slipping.
Rotary Tool - How-ToCarving Pumpkins with a Dremel Cordless Rotary Tool
Saw - How-ToHow To Flush Cut Baseboard
Saw - DIYReplacing Ceramic Floor Tile
Saw - DIYHow to Replace Damaged Plywood Subfloor