by Dremel ®
Tools & Accessories
2Paint- at least 2 colors
Let's Get Started
To reduce the risk of injury user must read instruction manuals for all tools used in this project. Wear eye and respiratory protection. Use clamps to support work piece whenever practical.
Begin by going to Dremel3D.com to download the models, from the "Tic-Tac-Toe Set"
While your pieces are printing, create your Tic-Tac-Toe board. Start by using your Dremel Saw-Max and SM500 accessory to cut a 14” square out of ¼” plywood.
Next, remove the sharp corners from the board. Do this by measuring 1 inch down from all four corners and drawing a line with a pencil. Cut this line using the Saw-Max again.
Then, smooth the edges of the plywood using the Dremel Multi-Max and sanding accessory. Continue sanding the top of the board to remove any rough area.
Once sanded, paint the board, keeping in mind you will need to paint lines over this color. The darker the board, the more coats you will need to for the lines to show through.
Once the paint on the board is dry, divide the board into nine squares, using a ruler and pencil. To create equal-sized squares, draw lines at 3 7/8 inches and 4 1/8 inches. As shown in the picture, place tape against the two lines, keeping the gap between the lines open to paint a distinguishing color. Repeating the same measurements from the first painted line, create two more parallel lines. Turn the board 90 degrees and repeat this two more times, making nine squares.
After the board is dry, gather the printed X’s and O’s and play a fun game of Tic-Tac-Toe.
A TOOL THAT CAN DO IT ALL
Experience Dremel's most powerful oscillating tool. Featuring 7.0 amps of power and 2 new, powerful cutting blades, the Dremel Velocity is the only tool you need.
SHOW US WHAT YOU MADE
Send us a photo of your Dremel creation so we can share it with the world.