by Dremel ®
Tools & Accessories
1Dremel 150 1/8" Drill Bit
1Sheet of 24" x 48" - 3/4" Thick Sanded Plywood
112" of 3/4" Wooden Dowel
1Hammer and 8d Finishing Nails
1Drill & 2 Wood Screws
1Paint & Paintbrushes
Let's Get Started
To reduce the risk of injury user must read instruction manuals for all tools used in this project. Wear eye and respiratory protection. Use clamps to support work piece whenever practical.
Begin by cutting out the bottom and sizes of the kit. You can complete all cuts using the Dremel Saw-Max and the SM500 Wood & Plastic Wheel. Measure, mark and cut the following 5 pieces: • Bottom: 12" by 4" • 2 Long Sides: 10 1/2" by 4 1/2" • 2 Short Sides: 8" by 6" Tip: In the interest of safety and accuracy, be sure to clamp your material.
Next, cut the top corners of your two short side pieces at an angle. To draw the lines of your angle: Make a small mark an inch and 1/4 in from either side on the top Make a small mark 4 1/2" from the bottom. Then, connect each of the top marks to the bottom mark. You can make these angle cuts with the same SM500 Wood & Plastic Wheel. With your material clamped, simply follow your marked lines of cut through the notch at the front of your Saw-Max tool.
Secure all pieces by nailing the sides together with finishing nails. For extra support, add wood glue along the seams of all sides before sinking nails in completely to the adjoining sides.
Next, cut your dowel handle to size at 12" long. Measure and mark your cut & with your dowel secure, make one quick cut across your marked line using your Dremel Saw-Max and SM500 wheel.
To attach your dowel rod, pre-drill the top to short sides of your homework kit. This process is easy with the Dremel 4200 and 150 Drill bit. Simply pull back the levers of the 4200, insert the bit, set your tool to high speed and sink the bit into the top of each short side of the kit. Hold the dowel securely between the two pilot holes and sink in a small wood screw through each pilot hole.
Finally, paint and personalize as desired!
SHOW US WHAT YOU MADE
Send us a photo of your Dremel creation so we can share it with the world.
A TOOL THAT CAN DO IT ALL
Experience Dremel's most powerful oscillating tool. Featuring 7.0 amps of power and 2 new, powerful cutting blades, the Dremel Velocity is the only tool you need.