Creating greetings Card
Selection of coloured card
Let's go - step by step
Draw a scalloped edge on your card and cut it out with an ordinary pair of scissors. Using the Dremel 7700, punch holes (parchment) using the diamond wheel point around the edge of the card either in a straight line or in groups of three.
Draw a borderline inside the card borders using the embossing pen and small flowers in each corner using one of the new Dremel templates. Sprinkle embossing powder over the pen lines. Shake the excess powder off.
Using the Dremel VersaTip with the hot air tip, carefully emboss the powder by holding the end of the tip a few centimetres away from the card.
Cut a piece of card fold it in half and glue the embossed card onto the front. Cut out a butterfly shape and decorate with the embossing pen and powder and heat with the VersaTip. Glue the butterfly body to the front of the card and raise wings away from the card to give 3D effect.