Clay Pot Hanger
  • Difficulty
    Medium

Brighten your space inside or out with this attractive hanging garden. This vertical clay pot hanger is perfect for adding touch of floral décor or a convenient hanging herb garden. Best of all, this garden décor is portable, allowing you to move your greenery inside for those colder months. Special thanks to the Home Depot Palm Harbor store for sharing this awesome how-to with us. Before you start the project, download and print the template using the "Design File" button above.

You need
Step17

Step 1

trace design on wood

You need:

We will begin by cutting wood for the body of the hanger. We created our hanger out of cedar as it typically withstands weather conditions outdoors. Measure and mark a 1" x 4" wooden plank to 46" in length. Mount the SM500 Wood & Plastic Wheel in your Saw-Max tool. With your plank clamped, turn on your tool and cut along the marked line.

Step27

Step 2

drill holes in wood

You need:

Trace the provided pot slot template onto the plank, flipping it to trace the template along the left and right sides as desired. We alternated the spacing of our slots, leaving at least 1' between slots located on the same side of the plank to provide room for each pot and plant. Our pots had a 5" height, 4" base diameter, 6" top diameter, and 1.5" lip height. Measure and mark a circle for a rope hole. We centered ours 1.5" below the top of the plank and gave it a 3/4" diameter. Optional: Draw top and bottom designs onto the plank. For our hanger, we brought the bottom of the design to a point by drawing lines from the bottom center of the plank to points marked 2" above the bottom of each side. Additionally, we beveled the top corners of our hanger design by measuring and connecting points 3/4" from the top and side of the plank for each corner.

Step37

Step 3

saw pieaces together

You need:

Using a drill and 3/4" spade bit, bore out holes at the top and bottom of each pot slot silhouette traced on the plank. Then, bore out the circle drawn for the rope hole using the same drill and bit. Tip: Clamp your plank to waste lumber when boring holes to prevent blow-out from occurring.

Step47

Step 4

oscialte places

You need:

Next, cut along the two traced lines that connect each oval pot slot to its respective side of the plank. This can be done using the Dremel Saw-Max tool equipped with the same SM500 wheel you used in step 1. Optional: If top and bottom details were added to the hanger design in Step 2, cut them out with the Saw-Max and SM500 at this time.

Step57

Step 5

sand rest of design

You need:

Mount the MM480 Wood Flush Cut Blade onto your MM30 tool. With your plank clamped, turn on your tool to a medium to high speed and cut vertically to connect each pair of bored slot holes. Tip: Let the speed of the tool do the work, not excess pressure. If you're noticing the blade is stuck mid-cut, back the tool out and plunge into your material again, working the tool side to side.

Step67

Step 6

Turn on your tool to a medium speed

You need:

Finally, we will sand the plank to give it a finished look. Attach the MM14 Hook and Loop Pad and MM70W Sand Paper to your MM30 tool. Turn on your tool to a medium speed, working in light circular motions and sand the body and edges of the plank as desired.

Step77

Step 7

Pull the rope through the cut hole

You need:

Pull the rope through the cut hole. Tie a knot to secure the rope to the hanger. Finally, hang the piece and load your potted plants. Required rope length will vary based on your desired hanging height. We used 10' of rope for our hanger.


Warning

To reduce the risk of injury user must read instruction manuals for all tools used in this project. Wear eye and respiratory protection. Use clamps to support work piece whenever practical.