Craft your own tealight holders
Give your home a cosy feel with these beautiful tealight holders. Make your tealight holders unique and enjoy the peaceful flicker of candlelight shine through these designs. Create the perfect gift using the Dremel 3000 for your loved ones all year round.
Step By Step Instructions
Pick your template
Print out a design as a template and cut out to the desired size.
Place the template
Take the template and place where you would like to securely fix it. When you have chosen the position fix it with tape on the tea light holder.
Using the acetone you can now easily transfer the template to the porcelain. Soak some kitchen towel with acetone. Then rub the acetone over the template and press down hard to ensure the pattern transfers.
Tip: Wear safety gloves and remove anything that is flammable
Now you can remove the template and see if everything has transferred. The ink does not last on the porcelain permanently, so be careful that you do not smudge the ink.
So that the drawing does not smudge while working, it is best to trace the image with a permanent marker.
Prepare your tool
The first step in drilling ceramics or porcelain is to pierce the porcelain. You start at a 45 degree angle and start to drill. Please first drip a little water on the place to be drilled. This is necessary so that the device does not over heat. Drill until the attachment sits well.
In the second step, place the drill vertically. Again, a drop of water is required. Drill until the water is gone and then apply another drop of water. These steps should be repeated until a hole appears to prevent overheating.
Note: Ensure to still apply drops of water. To avoid over heating always apply some water before drilling. Otherwise, the router can break quickly and easily.
When you are done with the pattern, remove any marker remnants with acetone. Also clean off any remaining drilling dust with water.
Now you only need one tea light and your beautiful tea light holders are ready!
To reduce the risk of injury user must read instruction manuals for all tools used in this project. Wear eye and respiratory protection. Use clamps to support work piece whenever practical.