Create this amazing centerpiece for your festive table

Fold your soft cloth or towel to create a cushioned surface and place the clear glass ornament down on top of it. Take your Dremel® 3000 with the Flex Shaft attached and insert the Diamond Wheel Engraving Point 7105 and engrave a series of larger and smaller snowflake motifs randomly around the ornament, leaving gaps in-between the designs. You need to be very delicate and under no circumstances should you press on the surface or you will shatter the fragile glas+I14s ornament. Be sure to wear your Dremel eye safety goggles.

Put a clear glue stick into the dual temperature Glue Gun 930 and place it in position on your Dremel Glue Mat. Switch the gun to the cool heat setting before leaving the gun to warm up. Then use your Dremel Glue Gun 930 to draw a delicate snowflake motif in-between the engraved snowflakes.

Working quickly so that the glue remains sticky, lay your Dremel Glue Gun 930 safely on the Dremel Glue Mat and, holding the ornament over the glass bowl with the white glitter, use the spoon to sprinkle glitter onto the tacky glue. Ensure the entire motif is covered in glitter before very gently tapping the excess off back onto the plate.

Allow the Dremel Glue Gun 930 times to cool down then fit it with a silver glitter glue stick. With your Glue Gun set to the cool temperature, apply silver glitter glue to further enhance and embellish the engraved and glittered motifs using the finished picture as a guide. Hang up the finished ornaments.