Traveling Jewelry Case

Traveling Jewelry Case

  • Difficulty
    Medium

Introduction

Keep your jewelry in one safe spot while traveling with this handy jewelry roll-up made out of a bamboo rolling mat.

You need
  • Ruler
  • Marker
  • Clamps
  • Hot Glue Gun
  • Bamboo Rolling Mat
  • Board
  • Leather Strip
  • Cardboard jewelry box
L: Length, W: Width, H: Height, D: Diameter
Step 1 4

Step 1

Place an old jewelry box on the bamboo mat, and draw a line

Start by placing an old jewelry box on the bamboo mat, and draw a line 1/4” to 1/2” wider than all ends of the box, leaving a slight overhang of bamboo.

Step 2 4

Step 2

Using the Dremel 3000 follow the drawn lines on the bamboo

Next, prepare to cut through the bamboo by placing it on a table with a board on top of the bamboo and clamps to hold it down. Using the Dremel 3000 and cutting wheel, follow the drawn lines on the bamboo to trim it down to the necessary size.

Step 3 4

Step 3

Take the leather strip across the bamboo

Then, take your leather strip and weave it across the center of the bamboo.

Step 4 4

Step 4

Pull up the glued bamboo side and press it to the box

Lastly, put glue on one of the longer sides and the bottom of the box. Then, place the box on the bamboo, leaving enough overhang to cover the side of the box. Pull up the glued bamboo side and press it to the box. Before you travel, place your jewelry in the box, close it by tying the leather strip together and pack it safely away in your luggage!


Warning

To reduce the risk of injury user must read instruction manuals for all tools used in this project. Wear eye and respiratory protection. Use clamps to support work piece whenever practical.