Create your own Idea Board

    Start organizing your thoughts with your new Idea Board!

    You need

    Using a Dremel DSM20 and DSM500 wheel, cut plywood

    You need:

    Measure the space you want your idea board to fill. Cut a piece of MDF or plywood to that size. Draw your cut lines on your MDF and clamp it onto your work table. Using a Dremel DSM20 and DSM500 Multipurpose Carbide Cutting Wheel, cut along this line. Easily achieve a smooth, straight cut- following the cut line through the notch at the head of the tool. Paint the newly cut piece with chalkboard paint and allow to dry.


    Using the Dremel DSM20 cut metal for magnets

    You need:

    Fill your idea board with various types of material including peg board, dry erase boards, cork board and more. Here, we wanted the ability to hang items with magnets so we chose to add sheet metal. To divide the board into 4 sections alternating metal and chalkboard surfaces, take the total measurement of your cut from step 1. Ours measured 36" wide by 36" tall. Divide this into 4 square tiles- 4 sections of 18" by 18" squares. Measure and mark your cuts for 2 of these quartiles in sheet metal and clamp it into place on your work table. With a quick accessory change, place a Metal Cutting Wheel into your DSM20. Following the marked line, move your tool slowly through the metal. Remember to let the speed of the tool do the work. Once your chalkboard is dry, drill your metal pieces onto the board. First drill pilot holes through the metal before screwing them into place.


    Drill your board agaiinst the wall

    You need:

    Finally, drill your board against your back wall.