How to create your own home bar sign

  • Difficulty

Give a name to the bar in your home by creating this sign with a Dremel rotary tool.

You need
  • Graphite
  • Paint and Paint Brush
  • 24” x 6” Pine board
  • 1 Tracing Paper
L: Length, W: Width, H: Height, D: Diameter
Step 1 4


Design pattern on paper

Start by designing your pattern on tracing paper, or use our “19th Hole” design, making sure the design will fit on your pine board. Cover the entire design with graphite, so in the next step it transfers to the board easily. Hint: Be sure to purchase the board with a routed edge, which can be found at craft stores.

Step 2 4


Place the paper and transfer to the board

Next, place the tracing paper on the pine board with the graphite side facedown, and transfer the design to the board by following the outline with pencil through the tracing paper.

Step 3 4


Dremel tool engraving the board
Board engraved with design

Using your Dremel tool and engraving accessory, follow the pattern transferred into the wood, creating a clean edge to the design. Then, sand the remaining outer portion of the wood by again following the pattern transferred to the board.

Step 4 4


Paint the design

After removing any dust, paint the board and add any embellishments preferred. Once dry, hang it up to give a name to your at-home bar!